OM CHAPTER 3 Li-Ion Battery Powered - with gesture sensor+TRAVEL CASE

9000mAh Li-ion batteries (up to 8 hours run time).

4 amps RMS, 7 amps peak.

2 to 12 volts.

Two outputs (you can connect two machines).

Self-protection against short circuit (overcurrent), overtemperature, overcharging and deep discharging.

3 memories per machine, 6 memories in total. Each memory can store a voltage and footswitch mode. Each small circle at the bottom of the display corresponds to a memory location.

Grooved dial allows 0.1V increase per step.

Push button in the encoder to turn the machine output on and off.

2 footswitch modes: a normal mode and a special mode. In special mode, a plate footswitch can be used like a switch (press once = on, press again = off).

Motion sensor to turn the machine on and off to avoid cross contamination. It is located on the left side of the power supply. See pictures. Motion detection allows you to turn the machine on/off, change presets/memories and switch between machines.

4 ways to turn the machine on and off (footswitch mode 1, footswitch mode 2, button on the dial, motion sensor).

Chronometer with hours, minutes and seconds.

4 neodymium magnets (20 kg holding force).

High quality aluminum housing.

Carrying bag included.

Bright 1.3″ display with plastic protection.

Electronic components of the highest quality.

Intuitive interface, easy to use.

Premium powder coating.

Size: 10×7.5×7.5cm